User's Manual

The Data Acquisition Box is secured to the stand by mounting clips and tightened with an Allen key. The

Allen key is provided with your system.

The power cord for the Data Acquistion Box is fed through the side of the computer management stand to

the power bar. The serial cord attaches to the back of the data acquisition box and is fed through the side

of the computer management stand and connected into the serial port in the computer.

All the power cords for the testing equipment on that side are plugged into this Data Acquisition Box. As

you will notice, each cord is labeled with a number and/or a letter, which corresponds to the same number

and/or letter on the top of the Data Acquisition Box. Provided for you, and already mounted above the

Data Acquisition Box, are clips for each cord coming out of the Data Acquisition Box. This prevents

constant bending of the cords at the connection to the box and prevents wear and tear on the cords.

Each piece of testing equipment on the left side of the stand has its own specific mounting apparatus.

Use the picture below as a guide to see where each piece of equipment fits. The coiled power cords for

the equipment should be plugged into the appropriate location on the Data Acquisition Box. When

plugging the equipment into the Data Acquisition Box make sure the pins are lined up properly to avoid

damaging the connectors.

Mounting Clips.