User's Manual

Connecting the UTM to the Data Acquisition Box

Within the packaging of your system, you will find one more gray serial cord with blue markings on it.

This cable will be used to connect the Universal Task Master to the front of the Data Acquisition Box.

Locate the back of the Universal Task Master (marked with a blue dot). One end of the serial cord is

connected to this side of the UTM. To allow for communication between the UTM and the Data

Acquisition Box, the other end of the serial cord (also marked with a blue dot) must now be connected to

the ‘TM’ port on the Data Acquisition Box.

This is the number 1

cable, which is

plugged into port

number 1 on the

back of the Data

Acquisition Box.

A black plastic wrap

is then used to

secure the loose

wires.