User's Manual

See below for the placement of the cables from the right and left load cells. Match the blue dots to attach

the cable that connects to the Data Acquisition Box.

You have now connected the Data Acquisition Box to the computer stand. The Data Acquisition Box

should now be in communication with the UTM.

Setting Up Your Data Acquisition Box

Take a moment to view the Data Acquisition Box. You will notice that the front of the box has nine outlets

and a green light bulb.

In order to use your ER System, connect the Data Acquisition Box to both the computer and the ER

System. In order to do so, locate the gray serial cords marked with red dots and a black power supply

cord supplied with your system.

The serial cord connects the Data Acquisition Box to the serial port on the back of your computer.

Connect the female end of the serial cable to the back of your Data Acquisition Box. For your

convenience, a red dot has been placed over the correct insertion for the cable -- simply match the red

dots together.

Match dots

and connect

cord