User's Manual

25
The same is true on your computer tower. Simply take the opposite end of the serial cord and connect it
to the proper port on the back of the CPU – this is also identified with a red dot for your convenience. Do
not plug the serial cable into a converter and then into a USB port in the computer.
To connect the power supply to your Data Acquisition Box, insert the single prong or pin into the “PS” port
located at the rear of you Data Acquisition Box. The opposite end of the power supply should be plugged
into a power adapter. Switch the Data Acquisition Box on -- the green light on the front of the box will light
up to indicate that the box is receiving power.
Attachments
The following is a list of ports that each integrated tool connects to:
1 – Bottom Shelf
2 – Top Shelf
3 – FOCUS Load Cell
4 – Hand Grip
5 – Pinch Grip
6 – Algometer
12 – Inclinometers
12G – Goniometer
12 – HR receiver
TM –Universal Task Master
You have now connected almost all of the basic components necessary for communication between the
ER hardware and ODES software. The final step is to plug the power cord to the power outlet.
On/Off Switch
PS= Power
Supply Cable
FP= Foot Pedal Serial Cable
connects to
serial port in
computer
Red Light – When
on means a tool
has shorted out the
Data Acquisition
Box