User's Manual

257
Connecting the UTM to the Data Acquisition Box
First connect the gray UTM integration cable from the UTM to the ‘TM’ port on the Data Acquisition Box.
Then connect the black coil cable from the left force scale to the center of the UTM and the black coil
cable from the right force scale to the center of the UTM.
Using the Universal Task Master
The software comes with two UTM tests already programmed:
UTM Standard Cart Pull Test
UTM Standard Cart Push Test
The parameters for these two tests have been set as follows:
Integration cable port
Right force scale cable port
Left force scale cable port
The black force scale cables should not cross at the center of the UTM.