User's Manual

261
On the first page of the new test, click Settings . If a red ‘X’ is displayed next to an item, there is a
problem reading that device or position. See the troubleshooting section of this manual.
Set up the UTM based on the settings selected when the test was created. Once the UTM settings are
correct, click OK to go to the test screen. After clicking Start a window will pop up reminding you to make
sure the client is not touching the UTM, so the device can zero itself. Click OK and the test will begin.
During testing, you have the option of collecting real time heart rate information by clicking Start HR or by
clicking Capture HR to add the data to the Heart Rate Report.
Once the test is completed the page will look like this: