User's Manual

290
Inclinometer and Goniometer
If the interface system cannot be launched when using the BTE Dual Inclinometers, ensure that:
The cords are properly connected (into the Data Acquisition Box and between the Master and the
Remote)
The Range of Motion test that is selected in ODES is designed for use with either the Inclinometers or the
Goniometer, or is non-integrated. Check the top left corner of the test page to determine which tool the
software is looking for.
If you receive this message upon entering a range of motion testing page, you may not have the Data
Acquisition Box set up properly, or the device may not be attached correctly. Upon entering the testing
screen, you will notice a red ‘X’ beside the testing tool. This indicates a lack of communication between
the tool and the Data Acquisition Box.
Ensure that the tool is in the correct port.