User's Manual Part 1

section 05
page
7
40040005 rev. 000
Step 12. Make sure the seat back is at its lowest position, and then raise the seat height to
its highest position (Figure 5-12). Click OK on the calibration screen.
Step 13. Once the device has been successfully calibrated, a screen will appear requesting
the name of the individual who just completed the calibration.
III. PERFORMING THE VERIFICATION
It is recommended that the accuracy of the device be verified after calibration. In addition,
verification should be completed prior to testing each day or after the equipment has been set
up.
Note that verification may only be performed on the head braces.
The Verification Screen can be accessed under the Calibration menu within the taskbar or
within the individual tool calibration screens (Figure 5-13).
The main verification screen will appear (Figure 5-14).
Figure 5-13. Calibration Drop-Down Menu
Figure 5-14. Main Verification Screen
Figure 5-12. Seat Height at Highest Position