User Manual

VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
27
When in Frequency (VFO) mode, select your desired receive frequency using the numerical keypad, or
use the tuning (left) knob on the front panel. After that, use the menu system to configure the finer
details of the channel you're wanting to program
into a memory, such as bandwidth, CTCSS or DCS and more.
Adding Scanning Channels
The following steps assume that you're in Frequency (VFO) mode and that you've entered the desired
frequency to store to memory.
1. Press the [MENU] key to enter the menu.
2. Enter 46 on the numerical keypad to get to RCH-AD.
3. Press [MENU] to select.
4. Use the and keys to select an empty memory channel or enter it directly on the
numerical keypad.
5. Press the [MENU] key to confirm.
6. Press the [EXIT] key to exit the menu.
Switch your radio to Memory (MR) mode by pressing the V/M button on the front panel, or press and
hold the Menu button on the mic to test your new channel. If you would like to name your channel you
will need to do that from a computer. More on that in the section called “Computer programming”.