User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
21
Chapter 3. – Basic Shortcuts and Use
Pound # Key
Keypad Lock
To enable or disable the keypad lock, press and hold the key for about two seconds.
A quick toggle of the # will alternate power levels from High power to Low power
The keypad lock will lock both the main radio buttons itself and also the handheld keypad.
The PTT/MONI/and Power Buttons will not be locked when enabled.
Star * Key
A short momentary press of the key enables the reverse function (reverses the TX/RX settings
according to Offset settings)
When listening to broadcast FM a momentary press will start the scanning. Scanning in
broadcast FM will stop as soon as an active station is found
To enable scanning, press and hold the key for about two seconds