User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
24
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
your frequency according to the frequency step you've set your transceiver to (Menu Item 1:
Step)
You can also input frequencies directly on your numeric keypad with kilohertz accuracy. However,
the radio will floor to the nearest frequency that corresponds to your frequency step, in other
words, when you input frequencies with greater than 1kHz resolution (such as 145.6875 MHz in
the example below), always round your input up.
Just because you can program in a channel does not mean you're automatically
authorized to use that frequency.
Transmitting on frequencies you're not authorized to operate on is illegal, and in most
jurisdictions a serious offence. If you get caught transmitting without a license you can
and will get fined, and in worst case sent to jail.
However, it is legal in most jurisdictions to listen. Contact your local regulatory body for
further information on what laws, rules and regulations apply to your area.
Channel (MR) mode