User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
25
The use of Channel (MR) mode is dependent on actually having programmed in some channels
to use. To find out more on how to program channels see Chapter 4, Programming.
Once you have channels programmed and ready, you can use the and keys to navigate
between channels (or Rotate the Selector Knob)
If you have channels programmed with Transmit power set to Low, you can use the
key to momentarily switch over to high power if you're having trouble getting through.
Monitor Both VFO & MR Modes
You can toggle from VFO and MR (Memory Recall) mode by either pressing the V/M button on
the front of your radio, or you can toggle modes from the Handheld Mic by a long press of the
‘Menu’ button.
The VFO/MR mode will only toggle on the current selected A/B/C/D line – while the other
channel lines will remain on channel or memory mode as they were selected.
This allows you to monitor channel and frequency mode simultaneously