User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
26
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
Chapter 4. – Menu Quick Review
Quick Menu Settings
(Full Definitions in Appendix A)
To set the Menu options from the Mobile body use the M Press the selector knob
on the radio body (or the Menu Key on the microphone) to select and confirm the
changes, while rotating the selector knob (or using the microphone arrow keys)
will change your settings.
0. [Enter Menu]+ [0] : TMR – This mode selects what displays are monitored in the
background besides the primary selected channel. You can mix and match between all
or partial channels to allow dual, tri, or quad watch
1. [Enter Menu]+ [1] : STEP – set the frequency increments step in VFO mode: 2.5kHz,
5kHz, 6.25kHz, 10kHz, 12.5kHz, 25kHz selectable.
2. [Enter Menu]+ [2] : SQL – Sets the receiver squelch level: 0 is OFF, 1 is the lowest setting
through 9 which is the highest setting.
3. [Enter Menu]+ [3] : TXP – Sets the transmit power setting from HIGH to LOW.