User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
29
information can only be set by the PC software)
21. [Enter Menu]+ [2] + [1] : PTT-LT - PTT-ID transmit delay setting. (Delay Time range is 0-
30 seconds.). This is the delay time before transmitting the PTTID
22. [Enter Menu]+ [2] + [2] : S-INFO - Signal information and automatic dialing memory. 1-
15 group signal code/decode memory. The memory list is programmed through
software.
23. [Enter Menu]+ [2] + [3] : EMC-TP - alarm mode settings. ALARM: turns on the alarm
sound on the device itself. ANI: Sends the Alarm and PTTID through the Transmitter.
BOTH: combines both of the options above. OFF: Disables alarm
24. [Enter Menu]+ [2] + [4] : EMC-CH - alarm channel setting. This is the channel that the
alarm will transmit the PTTID and Alarm sound on
25. [Enter Menu]+ [2] + [5] : SIG-BP – Pager Ring at Reception of Matching
2Tone/5Tone/DTMF (on/off)
26. [Enter Menu]+ [2] + [6] : CHNAME - channel name edit.
27. [Enter Menu]+ [2] + [7] : CA-MDF - Display Mode (Display A) - FREQ: displays Frequency.
CH: displays channel number. NAME: displays assigned channel name.
28. [Enter Menu]+ [2] + [8] : CB-MDF - Display Mode (Display B) - FREQ: displays Frequency.
CH: displays channel number. NAME: displays assigned channel name.
29. [Enter Menu]+ [2] + [9] : CC-MDF - Display Mode (Display C) - FREQ: displays Frequency.
CH: displays channel number. NAME: displays assigned channel name.
30. [Enter Menu]+ [3] + [0] : CD-MDF - Display Mode (Display D) - FREQ: displays Frequency.
CH: displays channel number. NAME: displays assigned channel name.