User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
31
41. [Enter Menu]+ [4] + [1] : RX-FC Receive Active Channel Foreground, Text Color: Color
options are BLACK, WHITE, RED, BLUE, GREEN, YELLOW, INDIGO, PURPLE, GRAY
42. [Enter Menu]+ [4] + [3] : TX-FC - Transmit Active Channel Foreground, Text Color: Color
options are BLACK, WHITE, RED, BLUE, GREEN, YELLOW, INDIGO, PURPLE, GRAY
43. [Enter Menu]+ [4] + [3] : Transmit Display – Status Bar Numerical Display Options
(Power Level or Mic Level)
44. [Enter Menu]+ [4] + [4] : MEM-CH - saves the selected channel.
45. [F Key} + [4] + [5] : DEL-CH - deletes the selected channel
46. [Enter Menu]+ [4] + [6] : SFT-D - Frequency difference direction setting. OFF: no
frequency difference. (+): Transmit offset amount will be a positive offset (higher than
the receive frequency). (
-): Transmit offset will be a negative offset (amount will be
lower than the receive frequency).
47. [Enter Menu]+ [4] + [7] : OFFSET - difference between the transmit and receive
frequency.
48. [Enter Menu]+ [4] + [8] : ANI – Displays the radio ID code. Code only can set by PC
software.
49. [Enter Menu]+ [4] + [9] : ANI-L - ID code length. Length = 3, 4, 5.
50. [Enter Menu]+ [5] + [0] : REP-S – Tone burst repeater settings. Pressing CALL will send a
predetermined tone. Options are 1000 Hz, 1450 Hz, 1750 Hz, 2100 Hz.
51. [Enter Menu]+ [5] + [1] : REP-M - repeater forwarding mode setting. Used in
conjunction with two radios connected as a repeater. OFF: turned off. CARRI: forwards