User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
32
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
after it receives a carrier call. CTDCS: forwards after it receives correct CT/DCS tone
TONE: forwards after it receives the correct 2Tone or 5Tone. DTMF: forwards after it
receives the assigned DTMF code.
52. [Enter Menu]+ [5] + [2] : TMR-MR – Transmit Delay Return time. Delay time before
returning to the primary channel after the secondary signal is clear. (PTT Return Time)
53. [Enter Menu]+ [5] + [3] : STE - Squelch Tail Elimination at the end of a received signal.
Requires both transmitting radios to have the option ON.
54. [Enter Menu]+ [5] + [4] : RP-STE - Repeater Squelch Tail Elimination requires a repeater
with this function ON. (Reverses the CT/DCS settings at the end of a transmission to
quickly turn of the squelch)
55. [Enter Menu]+ [5] + [5] : RPT-DL – Repeater Squelch Tail Eliminator Delay time. (use
with Menu 46)
56. [Enter Menu]+ [5] + [6] : DTMF-G – Adjust the gain of the DTMF tones. Selectable from
0-60. 0 being the quietest level and 60 being the loudest modulated DTMF tones.
57. [Enter Menu]+ [5] + [7] : M-GAIN – Adjust the gain the the Microphone. Selectable from
0-127. 0 being the quietest level and 127 being the loudest modulated microphone
audio.
58. [Enter Menu]+ [5] + [8] : SKIPTX – Quad Frequency Operation: Randomize transmitting
channels - with another corresponding mobile on the same 4 channels transmissions
can be spread apart on the four channels in 2 modes. [Off, Skip 1 (Randomizes in