User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
33
between after both transmitting and receiving), Skip 2 (Each PTT Press will
systematically go to the next channel (PTT (A), PTT (B), PTT (C), PTT (D), PTT(A), et.)
59. [Enter Menu]+ [5] + [9] : SC-MOD – Automatic Scan Resume Method: Off (Scan cancels
with key press, or reboot), PTT-SC (Scanning will resume after transmitting (or other
Menu Operations), MEM-SC (Scan Memory during Radio Reboot: If scanning was
active when the radio was powered down, the radio wil resume scanning on restart.
(Scanning also resumes after transmitting or other Menu Operations), PON-SC
(Power On Scan: The radio will start scanning upon turning on - no matter what
state it was in when powering down. Also the radio will scan after Menu operations
or Transmitting)
60.
[Enter Menu]+ [6] + [0] : RESET – Reset all VFO settings or ALL settings (channels
deleted and VFO settings cleared)