User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
42
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
2. Press [MENU] Key select 22 S-INFO, press [F] Key select pre-code signal group (1-15).
(The 5Tone Signal must be saved first in the PC software setting under 5TONE settings)
3. If properly set up (on Menu 18, and 19), your radio will open the squelch when it
receives the required 5TONE signal.
4. Press [Call] Key to send the same 5TONE you have selected in Menu 22.