User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
46
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
scanned. In other words: this would be done by listening to stations on the repeater's
input frequency.
Scanning for CTCSS Tone
(ACTIVE SIGNAL REQUIRED)
1. Press the key to enter the menu.
2. Enter on your numeric keypad to come to Menu 11: R-CTCS
3. Press the key to select. Insure you have a tone activated (and it is not off)
4. Press the to begin CTCSS scanning
A flashing "CT" will be in the left status display to indicate the radio is in CTCSS scanning mode.
In this mode, whenever the radio is receiving an RF signal on the selected MR channel or VFO
frequency, the lower display will cycle through the CTCSS tones as they are being tested. Once
the frequency of the received CTCSS tone is determined, the "CT" indicator will stop flashing.
Press the key to save the scanned tone into memory (VFO Mode Only) then press the
key to exit the menu.
Don't forget to set VFO menu 11 back to OFF when the CTCSS tone is no longer
required.