User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
47
Scanning for a DCS tone
(ACTIVE SIGNAL REQUIRED)
1. Press the key to enter the menu.
2. Enter on your numeric keypad to come to Menu 10: R-DCS
3. Press the key to select. Insure you have a tone activated (and it is not off)
4. Press the to begin DCS scanning
A flashing "DCS" will be in the left status display to indicate the radio is in DCS scanning mode. In
this mode, whenever the radio is receiving an RF signal on the selected MR channel or VFO
frequency, the lower display will cycle through the DCS codes as they are being tested. Once the
bits of the received DCS code are determined, the "DCS" indicator will stop flashing.
Press the key to save the scanned tone into memory (VFO Mode Only) then press the
key to exit the menu.
Don't forget to set VFO menu 10 back to OFF when the DCS tone is no longer required.