User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
57
with .600MHz transmit is a transmit Channel of 145.600MHz)
SFT-D and OFFSET only function in VFO mode.
MR mode uses and stores the RX frequency and the TX frequency directly (see Chapter 4)
The following instructions assume that you know what transmit and receive frequencies your
repeater employs, and that you're authorized to use it.
1. Set the radio to Frequency (VFO) mode with the key.
2. Enter the repeater’s output (your receiving) frequency by either using the and
keys, or by entering it directly on the numerical keypad.
3. Press the key to enter the menu.
4. Enter Menu 47 to get to frequency offset.
5. Press key to select.
6. Use the and keys and the numerical keypad to enter the specified frequency
offset. See the section called “26 OFFSET - Frequency shift amount” for details.
7. Press to confirm and save.
8. Enter Menu 46 on the numeric keypad to get to offset direction.
9. Use the and keys to select + (positive) or - (negative) offset.