User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
58
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
10. Press to confirm and save.
11. Optional:
a. Save to memory, see Chapter 4 for details.
b. Set up CTCSS; see the section called “CTCSS” for details.
12. Press to exit the menu.
If everything went well, you should be able to make a test call through the repeater. If you're
experiencing problems making a connection to the repeater, check your settings and/or go
through the procedure again.
If you're still unable to make a connection, contact the person in charge of the radio system
with your employer or your local amateur radio club, as the case may be.
If you for some reason want to listen to the repeater's input frequency instead, press
momentarily and you'll reverse your transmit and receive frequencies.
This is indicated in the LCD on the radio with an R in the top row, next to the + and - for
the offset direction.