User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
70
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
can be spread apart on the
four channels in 2 modes.
SKIP2
Alternates transmitting on A,B,C,D - each PTT
Press the radio will transmit on the next channel in
order of their display (A-B-C-D-Repeat)
59
SC-MOD
Automatic Scan Resume
Method
OFF
Scan is disabled with a Radio Reboot, or by
Pressing a Menu Key / PTT
PTT-SC
Scanning will resume after transmitting (or other
Menu Operations)
MEM-SC
Scan Memory during Radio Reboot: If scanning
was active when the radio was powered down,
the radio wil resume scanning on restart.
(Scanning also resumes after transmitting or other
Menu Operations)
PON-SC
Power On Scan: The radio will start scanning upon
turning on
- no matter what state it was in when
powering down. Also the radio will scan after
Menu operations or Transmitting
60
RESET
Initialize to Factory Defaults
VFO
Menu Initialization
ALL
Menu and Channel Initialization