User's Manual

mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 18
4 INSTALLATION
4.1 SYSTEM INSTALLATION OVERVIEW
This section provides instructions for installing the mBSC DAS system in an efficient, productive and
customer friendly order. Each component of the mBSC DAS system is covered in its own installation
section as follows:
4.2.REMOTE UNIT INSTALLATION
The Remote Unit installation section provides instructions for the mechanical and electrical installation of
the mBSC Remote Unit including: mounting the Remote Unit, connecting the fiber optics cables; Antenna
feed line; and AC power cables.
The procedures in this section assume that the required Fiber Optic cables have been routed between the
Host Unit and the Single-Band RU and that the required antenna has been installed.
4.3.HOST UNIT INSTALLATION
The Host Unit installation section provides instructions for the electrical installation of the mBSC Host Unit
including verifying the DC power cable connection, connecting the network cable, the alarm connectors,
and other required connections and cables.
The procedures in this section assume that the Host Unit has been inspected, the Remote Unit(s)
installation is complete and that a dedicated IP address for the Host Unit has been designated.
4.4.NMS INSTALLATION
The Network Management System (NMS) installation section provides instructions for setting up the
pre-installed software component of the mBSC NMS. The instructions will allow a qualified user to install
the NMS software, set-up accounts, change passwords for security, and upgrade the system software and
hardware.
The procedures in this section assume that the NMS server has been received, the Host Unit is installed,
and that security software has been installed on the designated NMS computer(s).