User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 22
3. Begin removing the Remote Unit(s) from the Mounting Panel by unscrewing the two (2) M8 fasteners
at the bottom bracket Interface end of the Remote Unit(s), Figure 4-4.
Figure 4-4. Remove the two M8 Fasteners
4. Remove the single (1) M8 fastener from the top bracket Fan end of the Remote Units and then remove
the two (2) M5 fasteners from the metal shipping bracket and discard the metal shipping bracket,
Figure 4-5.
Figure 4-5. Remove the M8 Fastener and the two M5 Fasteners
5. Remove the Remote Unit(s) from the shipping crate.
6. Unpack the Mounting Panel from the crate.