User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 25
4.2.4.2 Install The Mounting Panel
Use the following procedure to install the mounting panel on the pole:
1. Take one M12 screw and insert it loosely in one of the two top holes in the panel. Place the mounting
panel against the pole as shown in Figure 4-6.
2. Place one of the two I-Beam or U-Beam brackets on the back side of the pole so that it aligns with the
M12 screw.
3. Hand tighten the screw to hold it in place
4. Place the second M12 screw in the next hole at the top of the panel and loosely fasten the screw as
well. Continue until all four screws are in place as shown in Figure 4-7.
5. Use a wrench to securely fasten the screws through both panel and brackets until the panel is securely
attached to the pole.
Figure 4-6. Attach the Mounting Panel and Bracket to a Pole