User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 34
Connect the other end of the RF cable to the port labeled “TX_IN” on the SLAVE Remote Unit User
Interface as shown in Figure 4-17.
Connect the second cable to the port labeled "RX_IN" on the MASTER RU.
Connect the other end of the second RF cable to the port labeled "RX_OUT on the SLAVE RU.
Figure 4-17. RF cable connection between Master and Slave Remote Unit
1 Slave to Slave Connection: Connect an RF cable into the port labeled "TX_OUT" on the first SLAVE
RU User interface.
2 Connect the other end of the RF cable to the port labeled "TX_IN" on the next SLAVE RU Unit.
Continue connecting all SLAVE RUs in this manner, as shown in Figure 4-18.
3 Connect an RF cable into the port labeled "RX_OUT" on the first SLAVE RU.
4 Connect the other end of the RF cable to the port labeled "RX_IN" on the next SLAVE RU. Continue
connecting all SLAVE RUs in this manner.
5 Power may now be applied to all Master and Slave Units used in this configuration.