User's Manual

Table Of Contents

mBSC-H DAS System

Installation Manual Issue 7

Single Host Unit

Hardware and Fasteners

Customer Install

Factory Install

Rec'd

POI INTERFACE CABLE

The following is a list of tools and any additional materials required for the Host Unit installation:

 Small Phillips screwdriver

 Wire cutters

 Wire Harness (Required for Expanded Third Party Alarm)

4.3.3 Unpacking And Inspection

This section provides the instruction for receiving the equipment shipment, verifying all parts have been

received and checking that no damage has occurred during transportation. The Host Unit includes the

following items:

 Optional Cabinet with Host Unit installed as shown in Figure 4-19.

 Hardware and Fasteners described in Table 4-7, Section 4.3.2

Figure 4-19. Host Unit Cabinet

Use the following procedure to unpack and inspect the Host Unit and accessories:

1. Open the shipping packet and carefully unpack the cabinet or individual Host Unit from the protective

packing material.

2. Verify receipt of hardware and fasteners using Table 4-7

3. Check each optional cabinet for broken or missing parts. Check each Host Unit module for any

damage, particularly the Fiber Optic Port. If there is any damage or missing parts, contact BTI (Section

6) for an RMA and to reorder parts, if any replacement parts are required.