User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 43
Figure 4-21. Grounded Host Unit (shown with optional POI Unit, also grounded)
4. Tighten the screw, making sure the cable is securely connected before moving to the next phase of the
installation.
4.3.4.3 DC Power Cable Connection
Danger: Please use caution when working with DC power. Ensure all power is disconnected
before working on power circuit.
Warning: Verify that the Unit has been ground with an earth-bonding cable to the grounding
connector.
The DC power cable is connected during factory pre-installation.