User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 45
Figure 4-24. Alarm Interface
1. With wire cutting tools, prepare the connecting wires.
2. Loosen the screws in each connector.
3. Use the Input Alarm configurations shown in Table 4-8 and the Output Alarm configurations in Table
4-9 to determine the wire placement.
4. Slide the bared wires into the slot under the screw and tighten securely.
5. Plug all the alarm connectors into the Alarm Input interface as shown in Figure 4-25 and Figure 4-26.
Table 4-8. Input Alarm Configuration
NMS Alarm Status
Alarm
No Alarm
Expanded Alarm 1 (User Defined)
IN1/GND
IN1
Expanded Alarm 2 (User Defined)
IN2/GND
IN2
Expanded Alarm 3 (User Defined)
IN3/GND
IN3
Expanded Alarm 4 (User Defined)
IN4/GND
IN4