User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 46
Figure 4-25. Input Alarm Installation (Alarm On)
Table 4-9. Output Alarm Configuration
Alarm Type
On
Off
Major
COM1/NC1
COM1/NO1
Minor
COM2/NC2
COM2/NO2
Figure 4-26. Output Alarm Installation (Alarm On)
4.3.4.6 Connect the BIU/FIU Modules
Connect the BIU to the FIU-S with the provided interface cable using the following procedure:
1. Connect one end of the interface cable to the BIU port labeled "Tx1 Out".
2. Connect the other end of the cable to the FIU-S port labeled "Tx1".
3. Connect a second interface cable to the BIU port labeled "Rx4".