User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 52
NMS ACCESSORY
Quantity
Received
AC POWER CABLE
1
The following is a list of tools and any additional materials required for NMS software installation:
Laptop, Desktop PC and/or Terminal
Crossover Cable
Hub and/or Router
4.4.3 Unpacking And Inspection
This section provides the instructions for receiving the equipment shipment and verifying that no damage
has occurred during shipping. The NMS software is pre-installed on the server which is shipped with the
following:
Optional cabinet with NMS server and Host Unit installed as shown in Figure 4-32.
Installation cables and accessories as described in Table 4-12, Section 4.4.2.
Use the following procedure to unpack and inspect the NMS server and accessories:
1. Open the shipping packet and carefully unpack the cabinet from the protective packing material.
2. Verify receipt of accessories using Table 4-12
3. Check the server for visual damage. If there is any damage, contact BTI (Section 6) for further
instructions including an RMA, if necessary.
Figure 4-32. NMS Server
4.4.4 Verify Server software