User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 84
3. Click on RU in the Select Equipment section.
4. Select the Slot No. for the Remote Unit. Use Table 6-1 as a guide for determining the Slot, Fiber and
Type selections.
5. Select the Fiber value.
6. Select the Type of Remote Unit. Selecting the Type of Unit also designates the Master or Slave
configuration.
7. NMS creates a default name based on the chosen slot, fiber and type values selected as shown in
Illustration 6-13 and Illustration 6-14. The default name may be deleted and may be replaced with a
customer designated name as the RU Caption, if desired.
8. Verify that the Site Caption, Site Code and HU No. are correct for the Remote Unit being added
9. Click Add.
Figure 5-17 Adding Master Remote Unit