User's Manual

mBSC2500U-005-RUCM11
MBSC2500U-005-RUCM11 April 15, 2013
Page 37
20V AC(+/20% @50/60Hz) through a 15 Amp circuit breaker. The
shown in
A connectorized 3-wire power cable is provided with the RPM enclosures for the AC power connection,
as shown in this manual. The connectorized end of the power cable connects to the AC power port
located on the panel of the enclosure.
The AC power source must supply 110/2
AC power cable provides the wire leads for line, neutral and ground connections. The power cable must be
routed from the cabinet to an electrical junction box for connection to the AC power source. The power cable
is rated for indoor or outdoor use. Refer to the following procedure to install the AC power wiring:
1. Locate the RPM which is located at the multi-slot chassis of the Remote Node unite as
Figure 33.
Figure 33 RPM
2. Terminate the AC power supply wires red between the RPM and the local source of
coupling nut.
4.5 Installation Final Inspection
The following section provides a set of review procedures once the physical installation and connections are
that are requi
AC power.
3.
Tighten the
complete. Leave the source AC power
at the Host Unit and Remote Node in the OFF position (breaker open)
to prevent accidental power-up.