Instruction manual

3. BASIC CONCEPTS
The software Tipbx 5.4 allows the configuration of the last generation PABX telephone
exchange by BTicino, both version 1-8 and version 2-8.
It is advisable to read the PABX telephone exchange use instruction manual before using
Tipbx 5.4.
Two different approaches exist to configure the PABX telephone exchanges:
Guided Configuration
After answering a few questions, subdivided in subsequent steps (wizard), the
configuration of the telephone exchange can be carried out by means of DTMF tones
(telephone keys) sent from an indoor extension telephone.
Using this approach, most configurations can be configured.
Detailed Configuration
After the generation of the project by means of the guided configuration (the only
method to generate a new configuration project), should it be necessary to further vary
the configuration, it is necessary to use this approach that allows the complete
configuration of each single function present in the telephone exchange.
As function of this choice, necessarily the configuration must be sent to the PABX
telephone exchange by means of the function data downloading via serial port
(download).
Further functions in the application are:
Verification of the configuration present in the PABX telephone exchange by means
of the function Upload Configuration, allowing to visualise the current configuration as
a normal project.
This operation is done by means of a serial port.
Updating of the firmware version of the PABX telephone exchange always done by
means of the serial port.
Manuale Tipbx 5.4 Pag. 49