Instruction manual

6.6 Configuration Downloading
It allows to send the configuration data to the telephone exchange by means of the serial
communication protocol.
To carry out this operation, it is necessary that all extensions connected to the PABX are
in resting position (receiver hung up).
Note: The procedure to carry out during the configuration downloading phase, is the
following:
5. Switch-on the PABX
6. Insert the programming cable
7. Activate the Tipbx procedure
8. Remove the programming cable
9. Switch-off the PABX and wait for a minute
10. Switch-on the PABX again
By pressing the appropriate button, the following mask appears:
Before going on, the user must connect the PC serial port to the PABX telephone
exchange by means of the supplied cable.
The application automatically searches the serial port to which the PABX telephone
exchange has been connected.
During the data uploading, the following mask appears:
Manuale Tipbx 5.4 Pag. 80