User manual

6. In case of reversed connection, +12V DC is connected instead of +5V DC and Plusdeck2
is
damaged. In this case, you can get free after-sale service.
7. If power cable is not enough, you should buy Y jack to connect.
8. Plusdeck2 does not work if there's no power supply to power cable which is power box in
computer (in case of a failed power)or insufficient power supply because power capacity
is not sufficient.
1. Connect one side of the included 20 pin
cable to the Plusdeck2’s backside.
2. 20 pin cable has an up and down side,
make sure you connect it properly.
1. The power cable is connected to the inside
power supply and looks like the figure on the
left.
2. Power cable is supplied 12V and 5V as 4
pins and has an up and down side.
3. Before connecting the power cable to the
Plusdeck2, make sure the connecting parts
and properly aligned.
4. Properly connected power cable should be
should have angled sides on the bottom with
the red line of 12V to the left, when facing it.
5. Be sure to check the connection head,
since the color of the wire may vary.
1. Connect the other side of 20 pin cable
which is connected to the backside of