User's Manual

Dip Switch Table for Smart Touch
Connecting Tumo Xcel Drapery Systems to other controls
The Tumo Xcel Drapery System can be easily linked with most third-party control devices through the
low-voltage connecting port at the bottom of the motor. This port can be used to connect to both local
and network controls. BTX Supply can provide technical assistance upon request to meet your project
needs. With the Tumo Xcel Drapery System, only a BTX low-voltage wall switch is needed to perform
control operations. Simply connect the motor to a low-voltage switch by plugging one end of the provided
RJ-11-4 lead into the low-voltage port on the motor. Plug the other end of the modular wire into the
low-voltage port of the switch, and x the wall switch at convenient position.
Programming Smart Touch to a MMC
To program the Smart Touch to the MMC, push and hold program button
for a few seconds until the relay in the MMC clicks (if no motor attached)
or the system jogs. Test the Smart Touch by moving the botton either left or
right to activate the MMC.
A
LED INDICATOR
PUSH BUTTON SWITCH
SLIDE DIP SWITCHES
REMOVABLE BATTERY COVER
OFF/OPEN ON/CLOSE
Pull the Left shade Opens
(Button on the right master)
Pull the Right shade Closes
(Button on the right master)
Pull the Right shade Opens
(Button on the right master)
Pull the Left shade Closes
(Button on the right master)
NOTE: This is for a split draw system.