User's Manual
MMC Programming
1) Programming the Handsender for One Motor
Note: To put MMC into program mode, unplug the MMC for 30 seconds and then reconnect. The
program mode is now engaged for the rst three minutes the MMC has been plugged in. When pro-
gramming a new system, any Tumo systems within range that have been programmed within the last
three minutes must be unplugged to prevent them from becoming recongured to match the new
system. Each MMC can learn up to four channels. To delete all channels from a programmed motor,
make sure the MMC is in program mode and press the STOP and DOWN buttons simultaneously .
The MMC handsender can control up to 6 MMC’s or 6 groups of MMC’s. Before using the handsender, the
MMC needs to recognize the handsender. Put MMC into program mode and press the channel selection
button. This will light up the last channel that was selected. Press again and the next channel will be selected
and light up, etc. Continue pressing the channel selection button until the channel you wish to program is
selected and the corresponding channel number LED lights up, then press the stop button. Before the MMC
leaves program mode, press and hold the UP and DOWN buttons simultaneously. The selected channel
number will light up with a slow ash. The MMC will then react with a movement to indicate that the re-
ceiver is receiving the signal from the handsender and to conrm that communication between MMC and
handsender is established. Press the LEFT or RIGHT button to test. The channel has now been programmed.
2) Programming one Handsender to Control Multiple Receivers or
Multiple Groups of Receivers.
Note: When programming a new system, any Tumo systems within range that have been programmed
within the last three minutes must be unplugged to prevent them from becoming recongured to
match the new system.
Select channel on the handsender (for example, channel 2) by repeatedly pressing the channel selection
button until the "2" is lit. To program another MMC to recognize this same channel(2) repeat the same
programming procedure in step 1 for the new MMC. Six MMC’s can be programmed to be controlled
by the same handsender this way. Select this channel to conrm that a particular receiver has been pro-
grammed to communicate with this channel by pressing LEFT or RIGHT. You should see the system react.
Continue this procedure until all six channel number LEDs light up. All the MMC’s will now respond when
you press the LEFT or RIGHT button. Any one of the six channels can be programmed this way for a
group of receivers. In this case, each channel will control all the receivers in that group at the same time.
Right
Up
Channel
Indicator
Stop
Left
Down
Channel Selection Button