User's Manual

MMC Programming
3) Delete Channel Settings at the MMC
Using the CHANNEL SELECTION button, select the channel programmed to the MMC for which you
wish to cancel the channel setting. Press and hold the UP and STOP buttons until the receiver reacts with
4 clicks. This channel setting has now been deleted from the MMC. If you now press or hold any of the
directional buttons for that channel, the MMC should not click.
4) Replacing the Handsender Battery
The handsender is powered by two lithium-ion button batteries, model number: CR24300. This battery
style is fairly common and should be easy to nd at most retail stores that sell electronic equipment or
accessories. The battery will last for over two years under normal conditions. When the channel LED
numbers one and six are lit up at the same time, this means the batteries are almost dead and need to be
replaced. Open the handsender case with both hands by twisting the top edge of the handsender until
the entire front cover pops off. The cover may be a little tight to remove. When inserting the new batter-
ies, be sure to place the positive side down. After inserting the new batteries, replace the cover, and the
handsender will be ready for use.
Programming wireless RF Tumo switch to a MMC
Note: To program to a wireless RF switch, rst you must put the MMC into program mode as described
on page 21.
Once the motor is in program mode, push the open and close buttons on the wireless switch at the same
time. The track will react with a movement to indicate the motor is receiving the signal from the wireless
switch. If this happens, your switch is now programmed.
Push at the
same time
to learn to
the motor
Push at the
same time
to learn to
the motor