Operating instructions

SECTION If
MINIMUM CLEARANCES
WALL INSTALLATION
The BUCK STOVE Models 26000-8 and
27000-B must be installed
in compliance with
the instructions contained in this manual.
Clearance from
combustible walls and
ceilings.
The minimum lateral distance between any
part of the BUCK STOVE models 26000-8
and 27000-B are shown in figures 1 and
2.
Floor Protection
If a freestanding model of the BUCK STOVE
is to be installed on a combustible floor, a non-
combustible pad must be placed below it
to
protect the floor from radiant heat and burn-
ing material from the stove.
The pad must meet the following minimum
specifications:
A NOTE:
Oimonsion, Shown ."-
Minimum CI •• r.""" III
Combu .. i:'", Wilt
flO()( ProtoctOt _
Minimum Sin Chart "A"
FIGURE 1
Woll
16"
•Use a Listed Floor Protector or a Floor Pro-
tector made of a non-combustible inorganic
material equal
to 3/8" Thk. millboard having
a thermal conductivity of
K::: 0.84 BTUlF2HoF
inches.
Ft.
2
H. Degrees F.
ANOn:
Oimll'\'ttom 5hOYWfl .q
Minimum C .. .,..nc. to
Co~iUi'lb~ Waif.
16"
The BUCK STOVE must be positioned on
the pad so that there is a minimum
of 16"
from the front of the door to the front of the
pad, and a
minimum of 8" measured
horizontally from the sides of the stove to
the sides
of the pad.
CHART A
BUCK STOVE
MODEL
26000-8
27000-8
2S000
Floor Protector
MINIMUM
SIZE:
48" x 4S" x 3/S"
53" x 4S" x 3/8"
54" x 54" x 3/8"
FIGURE 2
CORNER
INSTALLATION
CAUTION: There must
be a minimum of 18" from any single wan pipe to a combustible
wall.
If there is not 18" from single wan pipe to the combustible waH, a wall
protector
must be used.
Page 14