Operating instructions
a.
Straight
up through ceiling:
(See
Figures 1and
2).
This is a simple installation normally used
when
installing
a BUCKMATE inside an existing room, and in some cases, in new construc-
tion. Refer
to
Figure 3 if an
offset
to
clear an obstruction is needed.
A CAUTIONĀ· Refer to chimney manufacturers
Instructions for assembly and disassembly
of chimney parts.
Be
sure to follow chimney
Instructions for proper clearances
to
comĀ·
bustlbles and proper air spacing required.
'\;:fi.!:r
Chimney
Cap
1-+-
__
'
__
Chimney Pipe
f=lT---
Storm
Collar
-_.-
Flashing
..
Elbows
+-:?"~"c--:-"::'
Adjustable
Chimney
_ ...
_--
Z.C.
Cabinet
FIGURE4
,
Chimney
Cap
- Flashing
Chase
Chimney Pipe
le.
Cabinet
EXTERIOR WALL CH/\SE
FIGURE3
OFFSET
TO
CLEAR
OBSTRUCTION
b.
Chase Installation:
(See
Figure
4).
A chase is
an
enclosure built specifically to house a
chimney. The interior of a chase is open from the BUCKMATE
to
the rool, eliminating the
need to cut through ceilings and the roof. Normally, a chase is built outside and against H'e
exterior wall
01
a home. A hole is cut through the wall, and the BUCKMATE is located in
He
bottom
of
the chase, with the front of the unit flush with the interior wall. Chases are
commonly veneered on the outside with brick, stone or wood
to
give the appearance of a
conventional fireplace flue. Occasionally, they are built inside and boxed in, similar to a
stairwell. When making a chase installation, it
Is
important to read the chimney manufa::>
turer's
instructions
prior
to
building, as there are specific requirements for bracing a Ire'}-
standing flue that must be planned for. There are also occasions where
olfsets
are used
within
a chase to accommodate unusual building designs, or to locate the BUCKMATE
further
into
a room.
NOTE: Chases require waterproof covers that are not commercially available due to
the
nonstandard designs of chases. Make sure that units fabricated by local sheet metal
shops completely overhang the chase and all masonry. Otherwise, rain leakage or frecz-
Ing and fracturing of standing water will occur.
Page 33










