Operating instructions

ELECTRICAL INSTALLATION
Electrical procedures: The BUCKMATE is not pre-wired; an electrician must wire the
8UCKMATE into the home wiring system using No. 14 AWG (with ground wiring) as minimum
in accordance with local wiring codes. (See Figure 4.)
1. Remove receptacle cover.
2. Remove receptacle from mounting box.
3. Run No. 14 AWG wire directly from house wiring in through the Field Connector in
the lower right side of the BUCKMATE. Leave 4-6 inches of wire extending out of
the
box.
4. Tighten Field Connector around wire.
5. Wire receptacle (black, white, and ground) and resecure to mounting box.
6. Replace receptacle cover.
GROUND HOUSE WIRING TO STUD
TO HOUSE
WIRING
FIGURE 4
POWER HOOK-UP
l'lOTE: During installation of the ZC-3-Q1/FP-201 combination, if it is ant.i~ipated ~hat the FP-201
may be replaced at a later date with the Model 27000-B Stove, prewmng as Illustrated above
is recommended to insure convenience.
Page 44