Operating instructions

i. Install the trim kit attaching it to
the BUCKMATE or finished
framing by using 1" screws to
secure the trim panels in place.
j. Remove cover plate from BUCK·
MATE exposing receptacle. Roll
up power cord so it will fit inside
of cover box. Plug in power cord
in receptacle. Replace
cover
plate. (See Figure 9).
k. Stove Doors are made of high
quality cast iron which resist
warpage over conventional
steel doors and should never
require hinge adjustment. Inside
glass and draft block mounting
screws should periodically be
inspected for tightness. If the
screw becomes loose, retighten.
I. Check primary air draft control on
each door.
FINAL CHECK-OUT
a
""",-
Sheet Metal
Screws
FIGURE 9
Perform final check·out as follows:
a. Remove all foreign material from stove and set firedogs in place.
b. Flip blower switch to AUTOMATIC. Blower should stop. The thermostat will automatically
cycle the blower on and off when a fire,is burning in the stove.
c. Open primary air draft controls on doors. and open damper completely.
d. Place a piece of newspaper in the stove. light it and close the doors. Ensure that the stove
draws properly through the primary air intakes. The paper should burn very quickly with a
pronounced roaring sound.
e. Open the doors and install the fireplace screen. Make sure that no smoke escapes from the
front of the stove with the doors opened. Smoking indicates a defective
or poorly positioned
chimney. If a thorough review
of the installation requirements does not reveal the problem,
contact your BUCK STOVE Dealer for assistance.
OPERATING INSTRUCTIONS FP-201 FIREPLACE
The FP·201 Fireplace Is designed for installation into the ZC·3·01 BUCKMATE Cabinet. These
units are preassembled at the factory and
do not require adjusting during installation. Use the
Fireplace as you would a conventional masonry fireplace. Except:
1) Use only the intergral grate provided with the unit. Do not elevate the fire.
DAMPER OPERATION:
Before building a fire, position the damper handle to the wide open position (up). After the fire
is completely out and all embers are cold, position the damper handle
to the fully closed posi-
tion (down).
CAUTION: When using the decorative appliance (gas logs), the fireplace damper must be
set In the fully open position.
Page 47