Operating instructions
FP-201 REMOVAL/27000-B STOVE INSTALLATION
The Fp·201 Fireplace may
be
removed and the Model 27000-B Stove
may
be
installed into
the
ZC·3-01
BUCKMATE Cabinet in its place. Follow the procedures listed below
to
accomplish this
change over:
1)
Remove the front trim panel from the cabinet
(3
vertical screws
on
each side and
2 screws on the power cord cover).
2) Spread the curtains to either side
to
give working room inside the firebox. Using a
9/16"
socket and rachet. loosen and remove the nuts
on
the
"T-Bars"
in
the damper
(locate these inside firebox
in
top-rear). Now remove the "T-Ba:s" from the damper
area. These
"T·Bars"
join the adapter stack
to
the fireplace damper opening.
3) Using a
9/16"
wrench, alternately turn the two nuts
on
each side of
the
adapter
stack
to
raise it !lway from the fireplace damper opening. These nuts
are
located
on the adapter stack.
Be
sure
to
raise it up far enough
so
that there
is
enough
clearance so
as
to be able
to
slide the fireplace out without hitting.
4) Now, remove the two mounting screws located
in
the curtain channel.
Use
a
3/8"
nut driver or socket and rachel.
5) The
FP-201
Fireplace is now tree to be removed from
the
BUCKMATE Cabinet.
Simply grasp the sides, top, or bottom and pull the unit straight oul.
6) Now, refer to page
38
for instructions on installing the Model 27000-8 Stove into
the Model
ZC-3-01
BUCKMATE Cabinet.
.......
_-
Adapter
__
--rC-.-_-r
Slack
ZC·3·01
Cabinet
--t---
Trim
Panel
--
Screw
LocatIOn
Mounting
Screw
;«..<~-r--
Localion
Fp.201 Installed in ZC·3-01 Cabinet
FP-201 Assembled View
Page 49