Technical data

ManualsBrandsBuckMaster ManualsKitchen AppliancesZC-3-01

Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers

TAPESWITCH CORPORATION Phone: 631-630-0442

100 Schmitt Boulevard 1 Fax: 631-630-0454

Farmingdale, New York 11735 www.tapeswitch.com

MANUAL Reset Controllers

Model Description Part Number

ZC-1 1 Zone Controller 0421

ZC-2 2 Zone Controller 0422

ZC-3 3 Zone Controller 0423

ZC-4 4 Zone Controller 0424

AUTO Reset Controllers

ZCA-1 1 Zone Controller 0431

ZCA-2 2 Zone Controller 0432

ZCA-3 3 Zone Controller 0433

ZCA-4 4 Zone Controller 0434

ZC Series

Zone Monitoring Controllers

Installation Instructions

Summary of content (7 pages)

PAGE 1
Release 02/2008 Ver. 2.
PAGE 2
Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers CONTENTS 1. INTRODUCTION Page 1. INTRODUCTION 2 2. PRINCIPLES 3 Tapeswitch ZC Series zone controllers are versatile, easy to install electrical controls, made for industrial applications and duty. They simplify the interfacing of conventional sensing switches to industrial systems. Tapeswitch controllers feature: ZONE SENSING RESET LOGIC OUTPUT CONTACTOR 3. APPLICATIONS 4 4. INSTALLATION 5 5.
PAGE 3
Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers (and the controller will trip) upon any of the following conditions: 2. PRINCIPLES The basic function of these controllers is to turn off or on a single powerful machine in response to low power, low voltage inputs. One load circuit is controlled, based on sensing switches connected to the different zone inputs. Depending on the model selected, there may be one, two, three, or four independent input zones.
PAGE 4
Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers When safety is involved, only the manual reset controller should be used. Machine operation based on operator presence-sensing is a dangerous application, forbidden by OSHA in most instances. An example of a dangerous AUTO Reset application would be a safety mat used in front of an NC punch press. The mat only causes the press to halt while the operator is on the mat.
PAGE 5
Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers 4. CAUTION INSTALLATION When used to guard a hazardous location, the controller must be a manual reset type, and be located in a safe area, away from any hazards being guarded. This is common sense. The operator should never be able to re-energize the controls while in a hazard area.
PAGE 6
Release 02/2008 Ver. 2.0 5. Installation Instructions: ZC-Series Controllers 6. OPERATIONS SERVICING TROUBLESHOOTING CAUTION: The following steps will usually isolate any problems in a ZC Series zone controller system: Be sure the controller has been properly connected before attempting to operate the unit. - De-energize the load until the controller has been checked out. BASIC OPERATION - Check that all wiring is secure and proper. START UP: Turn on the power. The green power lamp should light.
PAGE 7
Release 02/2008 Ver. 2.0 Installation Instructions: ZC-Series Controllers PARTS REPLACEMENT INFORMATION TECHNICAL SPECIFICATION Part Description LED Circuit Board (AUTO Reset uses the same part as the manual reset listed here) ITEM Power Required Zone Circuit Board, Manual Reset models Zone Circuit Board, AUTO Reset models Model Part Nr.