K HZg^Zh >> HjeZgYg^kZ K"'% K")% &&' 8DB7D '&' 8DB7D =:69
*OUFOEFE UP BMFSU UIF VTFS UP UIF QSFTFODF PG VOJOTVMBUFE ²EBOHFSPVT WPMUBHF³ XJUIJO UIF QSPEVDUµT FODMPTVSF UIBU NBZ CF PG TVGGJDJFOU NBHOJUVEF UP DPOTUJUVUF B SJTL PG FMFDUSJD TIPDL UP QFSTPOT *OUFOEFE UP BMFSU UIF VTFS PG UIF QSFTFODF PG JNQPSUBOU PQFSBUJOH BOE NBJOUFOBODF TFSWJDJOH JOTUSVDUJPOT JO UIF MJUFSBUVSF BDDPNQBOZJOH UIF QSPEVDU $"65*0/ 3JTL PG FMFDUSJDBM TIPDL ± %0 /05 01&/ $"65*0/ 5P SFEVDF UIF SJTL PG FMFDUSJD TIPDL EP OPU SFNPWF DPWFS /P VTFS TFSWJDFBCMF QBSUT JOTJEF 3FGFS T
*.
8*$)5*(& 4*$)&3)&*54)*/8&*4& "$)56/( #FJN &JOTBU[ WPO &MFLUSPHFSjUFO NTTFO V B HSVOEMFHFOEF 7PSTJDIUTNBOBINFO CFGPMHU XFSEFO -FTFO 4JF TJDI EJFTF "OXFJTVOHFO EVSDI #FXBISFO 4JF EJFTF "OXFJTVOHFO BVG #FBDIUFO 4JF BMMF 8BSOVOHFO #FGPMHFO 4JF BMMF "OXFJTVOHFO 4FU[FO 4JF EJFTFT (FSjU OJDIU JO EFS /jIF WPO 8BTTFS FJO 3FJOJHFO 4JF FT OVS NJU FJOFN USPDLFOFO 5VDI
*/4536$5*0/4 *.
*/4536$$*0/&4 *.
Budda™ V-Series™ II Superdrive™ Guitar Amplifiers Thank you for purchasing the finest tube amplifier in the business. We appreciate your support and look forward to providing you with years of trouble-free service. Before we get into the features of your amplifier, we would like to note that tube amplifiers require a little bit of care and maintenance to ensure many years of service.
Mid: Use this push/pull control to dial in your midrange frequencies. Mids are the most active part of the EQ circuit. Cutting scoops your tone, sort of like creating a “V” in a graphic equalizer. Boosting them will add more fundamental guitar frequencies. • Pull “Thick”: Pulling this control will add fullness to the tone of the amp. This is more noticeable in the Drive mode, but affects the Rhythm mode as well. Treble: Use this control to dial in your treble frequencies.
Slave: The Slave out is a 100-ohm compensated signal that is in parallel with the speaker output. It contains the full complement of preamp and power amp characteristics of your amp. Use this output to send your signal to a power amplifier connected to additional speaker cabinets for a louder version of your amp. Slave Level: This controls the level of the output from your Slave out.
x One simple test to determine whether your amp is experiencing preamp or power tube problems can be performed by plugging your guitar into the effects return of your amp: x If the static or squealing noise continues, then the problem is related to the power tubes or driver tube (third from left) and they should be replaced. x If the static noise goes away, then the first or second preamp tube is the culprit and should be changed.
V Series™ II Superdrive™ Rear Panels and Tube Complement V-20 Rear Panel 12ax7 12ax7 12ax7 6v6 6v6 5u4 V-40 Rear Panel 12ax7 12ax7 12ax7 6v6 6v6 6v6 6v6 7J996#8DB
7J996#8DB ;ZVijgZh VcY heZX^ÄXVi^dch VgZ hjW_ZXi id X]Vc\Z l^i]dji cdi^XZ Eg^ciZY ^c i]Z J#H#6# -%(%'+%)