User's Manual

21
levels and set up Alert notifications levels for unusually high
or low levels of activity. One may filter this list to view
activity by a date range.
Locate
Log in at www.Link–Mobile.com, select the
Wearer icon, and then click on the Locate icon.
One may filter for a given date range of historic
locations and even download a PDF copy of a
route traveled to share with friends. From here, one
may also make a request for the system to find the
Communications Clip’s current location. To see current
location, select Update Location. The process of locating
the Clip and reflecting its location on the map can take up
to five minutes. If you are having trouble locating the
Communications Clip, refer to the Troubleshooting section
of this manual. Status of the Clip and Wristband (including
if on the charging Dock, battery level, and street view) can
be seen from the table. Select the map type (street,
satellite, hybrid) by checking the blue plus sign in the upper
right section of the map. Zoom in or out until you can see
your desired geography.
NOTE: Since GPS signals can waiver and report spurious
locations, selecting “Significant Only” forces the system
to limit signals to only the strongest and most consistent
signals.
Zones
Log in at www.Link–Mobile.com, select the
Wearer icon, and then click on the Zone icon.
Clicking on Add a Zone allows users to
graphically depict Safe and Unsafe areas. By
defining a zone, you can then set up a Notification to be
sent to emergency contacts should a Wearer leave an area
or not enter an area by a given time. Alerts, based on day
and time of day, can be defined for entering or leaving
these zones. Start by naming your zone and entering a
starting street address. Select the map type (street, satellite,
hybrid) by checking the blue plus sign in the upper right
section of the map. Zoom in or out until you can see your
USING LINK–MOBILE