User's Manual

6
INITIAL SET-UP
Prior to using your Link–Mobile system for the first time, it
is important to charge all components fully. This will take
approximately three hours.
To charge the system, plug one end of the white charging
cable into the Dock, and insert the other end of the cable
into the AC power adaptor. Plug the AC power adaptor
into an electrical outlet.
To charge the components of your Link–Mobile system, first
place the Wristband on the charging Dock, then place the
Communications Clip on the charging Dock, as shown in
the photo. The LEDs in the Wristband and Communications
Clip will briefly light green when properly seated.
When you are at home, the Clip can be left on the Dock
and will always be charging. The Night Mode button on the
Dock allows you to dim the LEDs at night. Should the Clip
be misplaced while in the range of the Dock, pressing the
Find Clip button on the dock will cause the Clip to send out
BEFORE YOU START
Clip left on Dock will be kept
fully charged.
Wristband and Clip LEDs
will briefly light green when
properly seated, blink green
while charging, then be solid
green when fully charged.