User's Manual

WARNING:Reserved pins must not be connected.
NOTE:
If not used, almost all pins should be left disconnected. The only exceptions are the following
pins:
RTS pin should be connected to the GND (on the module side) if flow control is not used
pin
signal
F1,F2,F3
VBATT & VBATT_PA
G1, C2, C7, E5, E7, G5,
G4, G3, H3, H6
GND
B1
ON/OFF*
A3
TXD
C1
RESET*
A4
RXD
A1
RTS
D1
TXD_AUX
E1
RXD_AUX
H1
Service